Dewey Mister's clog free reliability provides you with the simplest yet most efficient growing methods around.

The Dewey Mister Aeroponics patented mister head is a first of a its kind. This new mister head circulates the water and feeds your plants roots at the same time all with a single air pump in the most efficient and sustainable way possible. The Dewey Mister eliminates the need for a water pump, jet sprayers, or air stones. This is a none clogging mister that allows you can use organic solutions without breaking down. 100% air driven means there is no water pump heating your reservoir. With out a water pump in your reservoir the nutrient water stays cooler, therefore reducing the chances for algae growth. Aeroponics has finally been simplified. With as little as six Dewey Misters and a 18 watt air pump you can run up to a 60 site cloner. The Dewey Mister is the ideal tool to refurbish or retrofit any clone machine, reservoir, or grow tray, and it also versatile enough to be used to brew Compost Teas or aerate your reservior while allowing for a simple cleanup.

The Dewey Mister is Made in USA. from nylon 6 food/medical grade material.

The Dewey Mister Saves energy using a low watt air pump, and requires far less water and Nutrients than other devices that claim to be efficient.

Instructions

Step 1.) Remove Dewey Mister from packaging, and slide the mixing chamber into the top of the base. Press the two pieces together until the water inlet hole is just above the lip of the base. Depending on water level and pump pressure, you may elect to partially cover the water inlet hole with the base. Do not completely cover the water inlet hole.

Step 2.) Attach air line to the base of your Dewey Mister.

Step 3.) Attach suction cups to the Dewey Mister base. Lubricate them with saliva, water, or vegetable oil before firmly pressing the center of all three suction cups to the bottom of your growing container. Your Dewey Mister should now be secured in place.

Step 4.) Run the airline from your Dewey Mister, and attach it to your air-pump by feeding the airline into the notch of the lid before sliding the lid shut. If you are assembling your own bucket system, just drill a small hole in the side of the bucket near the top. Do not drill a hole in the lid itself. Run the airline through the hole, and attach it to your air-pump.

Step 5.) Make sure your bucket is free of debris before adding water. Note the Min and Max levels of the mixing chamber. Fill bucket with water of your choosing between them

Step 6.) Place the soft rubber Dewey Inserts into the holes of your lid. If assembling your own bucket cloner, use netcups and/or neoprenes to fill each hole.

Step 7.) Make sure your lid is on and each hole is covered before plugging in your air-pump. Let the system run for a few minutes, then check to see that the bottoms of your inserts are gathering moisture. To make adjustments, either add or remove water from your bucket, or simply cover or uncover the water inlet hole with the base of the unit, and you should be good to grow. Happy cloning